![]() ![]() ![]() The arm that attaches the float chamber to the mixing chamber can be one of several angles in order to keep the float vertical and can be angled to the left or right dependant on which side it is attached. In addition to the variation of carburettors listed above there is a profusion of float chambers. Mixing chamber tops can have one, two or no threaded holes for cable adjusters there is an adjuster on the carburettor OR in the cable, not both, see main listing for details. The needle position is the number of grooves from the top. Standard needle jets are not usually marked. Or replace the basics and seals with our overhaul pack here (monobloc only) Type 6 Carburettor Settings ChartĪ standard needle jet is used on the type 6 models unless a size is given. The prices for re-sleeving are found under RES169 or RES170 for a complete overhaul. The new Monobloc carburettors that are now available have improved materials. This is preferable to fitting a non-original later type of concentric carburettor. The materials used in this process will last a lot longer than the original. Wear is likely to be apparent as early as 5,000 miles, but can be rectified by boring the body oversize and fitting a sleeve to the slide. Fitting a new slide in a worn body is like fitting a new chain to old sprockets, a waste of time. Poor starting and erratic tick over is usually caused by wear between the throttle valve and the body. Type 6 Carburettor 1929-54 Carburettor Problems Ordering, Payment, Back Orders, Returns. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |